Finally
Apr 25, 2022 19:32:52 #
Bcmech1 wrote:
Where there's a will, there's a way
Yeah, Bc that’s pretty much my motto…
🐟onApr 25, 2022 19:36:09 #
Kerry Hansen wrote:
Great job Doz, it is good to keep the old Gray Matter exercised!
Thanks, Kerry. Yeah I clean the cobb webs out every now and then…
🐟onApr 25, 2022 21:43:37 #
Able Man
Loc: North Coast (Cleveland, Ohio)
Good job, Dave! I'm SURE you could've had a jod of "Engineer", on a few of the bigger boats, I'd worked on! (Hell, if they "let ME do it"; I'm sure that any of them would have appreciated your fabrication skills.) It's a shame about that $100, though... ¿Maybe try and "send it back"?
Apr 25, 2022 22:04:24 #
Able Man wrote:
Good job, Dave! I'm SURE you could've had a jod of "Engineer", on a few of the bigger boats, I'd worked on! (Hell, if they "let ME do it"; I'm sure that any of them would have appreciated your fabrication skills.) It's a shame about that $100, though... ¿Maybe try and "send it back"?
Thanks Able. I’m not so sure about “Engineer” but I do pretty good on a “redneck” level. They’re replacing it, should be here tomorrow. Then I’m going to try to return that one for a refund. I don’t need a tool that’s going to break every time I use it…
🐟onApr 26, 2022 11:21:41 #
rman4443
Loc: New Hampshire, Concord area
DozerDave wrote:
Well, the seal’s and O-rings and water pump kit fo... (show quote)
Great job! The best way to "weld" cast iron, is to silver solder or braze it.
Apr 26, 2022 11:57:48 #
rman4443 wrote:
Great job! The best way to "weld" cast iron, is to silver solder or braze it.
Your right, rman. But that method wouldn’t stand the stress of a gear puller…
🐟on
If you want to reply, then register here. Registration is free and your account is created instantly, so you can post right away.