Home made rod holders
Dec 18, 2019 22:02:20 #
Wv mike wrote:
In action on Kentucky lake my best friend and myself.
You would spend the rest of your life in prison if you did that in California. LOL.
Only two rods for inland waters, and if you want to use two rods you have to purchase a second rod sticker on your license.
Dec 18, 2019 22:08:54 #
Dec 18, 2019 22:16:08 #
EasternOZ wrote:
Too many rules.
That's for sure.
Used to be if you caught a salmon here it was considered occasional catch, now you better have a salmon sticker. Southern California.
Dec 18, 2019 22:16:19 #
The only place wv has a rod limit is where they stock trout and it’s two rods, and that’s lifted after the first day of June.
Dec 18, 2019 22:26:57 #
I like the rig WV Mike . I've got an idea for that too. Its coming. Not as nice as yours though.
Dec 18, 2019 22:31:51 #
I was by myself on one of our local lakes had both sets of holders and I managed to get all 8 rods out I was doing good catching crappies I was quite busy it was going good until about a five pound catfish grabbed one of my rods my rods range from 12 to 16 foot long and are kinda like buggy whips. By the time I got him in 6 of my rods was involved what a mess
Dec 18, 2019 22:43:10 #
Dec 18, 2019 22:54:21 #
Rob just a thought on your holders I can see a slotted screw that holds the pvc to the pipe you might try to slot the pvc add a finder washer under the slotted screw that way you can change the pitch or angle the rod sets.
Dec 19, 2019 00:12:58 #
Those are very good and I have seen many like that in various shapes.
Dec 19, 2019 08:56:09 #
Rob March wrote:
So I was looking at rod holders for the boat. Didn't like the prices. ( I'm disabled , money very tight ) . my daughter sent me some ideas she seen on a DIY site. So I went to the shed and now I've got rod holders.
Hey Rob, I am drawing a blank here. Where did you find the white holder part?
Dec 19, 2019 09:05:26 #
plumbob wrote:
Hey Rob, I am drawing a blank here. Where did you find the white holder part?
Pvc pipe?
Dec 19, 2019 09:33:42 #
Dec 19, 2019 09:46:58 #
Rob March wrote:
Got an idea for the pre locks also. When I make them I'll post them. All this I'm doing is trial and error.
Priceless education for the rest of us.
Dec 19, 2019 09:49:04 #
EasternOZ wrote:
Pvc pipe?
You may be right E, I would assume he took a Dremel to it for the cut outs.
Where is my 3D printer when I want it?
Dec 19, 2019 10:11:53 #
plumbob wrote:
You may be right E, I would assume he took a Dremel to it for the cut outs.
Where is my 3D printer when I want it?
Where is my 3D printer when I want it?
Amazon
If you want to reply, then register here. Registration is free and your account is created instantly, so you can post right away.