I back mine in far enough to get water to jet. Get in make sure she'll start. Get out unhook winch hook. Clip rope on cleat tie other end to bed tie down. Back in till she floats. Get out pull it to bank or dock tie off park go fishing. Loading I spray silicone on boards bury trailer pull up till top of fender is showing. Tailgate down. Put on the bow stop hook safety chain step on tailgate. If water too deep I'll go over the bed side. Pull up till nose is out of water. Tighten winch strap n get off ramp. Do the rest in parking lot 👍👍
No, you don’t wear tennis shoes inside your waders . Just your socks.
Fredfish wrote:
I've anchored my 28 footer in 6ft seas with a 1/2"anchor line, and towed a 36ft Chris Craft Motor Yacht, with 1/2" line and never had an issue. I think you need better quality rope. What kind of cleats does your 18footer have, that you can tie a
1 1/2" line to?
Yeah, Fred. My question also. 1 1/2 is huge…🤷♂️🐟on
DozerDave wrote:
Yeah, Fred. My question also. 1 1/2 is huge…🤷♂️🐟on
I always used 3 strand and its plenty strong, but the braid is even stronger. I use 3/8" on the aluminum boat.
Fredfish wrote:
I always used 3 strand and its plenty strong, but the braid is even stronger. I use 3/8" on the aluminum boat.
I’ve got 1/2” braid. Strong and easy to handle. Coils really nice…
🐟on
MuskyHunter wrote:
I tried the liquid rollers and it worked very well.
I then tried MUCH cheaper silicone spray and it worked just as well as the liquid rollers.
I looked up the price of liquid roller $25/$28 I get six cans of cheap silicone at Walmart for that price
I water my mucks, the silicone work like a dream but for me to have it work I had to treat the bunkers after I parked the trailer and before I picked the boat out again. Few times of that then you can get away with 4 or 5 launches before you need to treat them again.
Callturkey wrote:
I water my mucks, the silicone work like a dream but for me to have it work I had to treat the bunkers after I parked the trailer and before I picked the boat out again. Few times of that then you can get away with 4 or 5 launches before you need to treat them again.
My tracker sets high so I craw under mine n spray down ea side of my bunks before I leave for the water. Then I spray again before I back in.
Billycrap2
Loc: Mason county,W(BY GOD) Virginia, 🇺🇸🦅
DozerDave wrote:
I launch my boat (18’ deep V aluminum on carpet bunk’s) by myself every time. Whether I’m by myself or not. I’ve got a 25’ rope permanently fixed on a cleat on the front left corner of the bow. On the other end is a loop. I coil the rope and lay it on the bow and after I’ve unsnapped the winch hook I hook the rope loop on the winch handle. I back down into the water until the boat floats off the trailer then pull up a bit get out and take the rope off the winch handle and tie it either to the dock or pull it up to the bank. To load it on the trailer I back in deep enough so that I can drive it up on the trailer. Crawl out over the bow. Hook up, cinch up the winch and pull out. Feet never touch the water. That’s what works for me…🐟on
I launch my boat (18’ deep V aluminum on carpet bu... (
show quote)
Yep that work for me too 👍🏽👍🏽👍🏽
FS Digest wrote:
I was recommended hip boot waders for when I launch my boat. I always have to get pretty deep in the water and push the boat off the bunks by hand. I'm gonna try spraying some silicon spray in the bunks to slicken them up. Reading and watching videos I can't tell if you can wear sneakers inside waders.
--
by broadd122
Some waders DO require shoes. If your waders don't have boots built into them then they require shoes. The shoes are worn OUTSIDE the waders. They are needed so that you don't punch a hole in the waders and get a leak. You can use an old pair of tennis shoes but they make wading shoes that can also be worn over the waders.
I use a heavy tow to pull on the wench connection, where I can back boat into the water, boat floats off the trailer. After a year plus of the rope being under the boat, towed down the road. Cleats are not an option, anchor ropes can not stop a 2000 plus lb boat moving back and then being towed back to shore. People have no idea, how I launch, no docks during November. They have been removed for winter.
As for the wader question, sneakers are not for inside hip waders. You can purchase stocking foot waders, then sneakers go over the wader.
jigginjim wrote:
I use a heavy tow to pull on the wench connection, where I can back boat into the water, boat floats off the trailer. After a year plus of the rope being under the boat, towed down the road. Cleats are not an option, anchor ropes can not stop a 2000 plus lb boat moving back and then being towed back to shore. People have no idea, how I launch, no docks during November. They have been removed for winter.
As for the wader question, sneakers are not for inside hip waders. You can purchase stocking foot waders, then sneakers go over the wader.
I use a heavy tow to pull on the wench connection,... (
show quote)
I pulled a 20,000lb Chris Craft , 3 1/2 miles in a 2-3ft chop with 1/2" 3 strand. It didn't even fray at the cleats. Just Say'n.
If the weather is warm I wear shorts and sandals. In cooler weather waders. As for the silicon spray, works like a dream. Be careful if you have steep ramp .
If you want to reply, then
register here. Registration is free and your account is created instantly, so you can post right away.